Warning: Disconnect power before servicing.

Electrolux Oven Error Codes

All Electrolux oven error codes with step-by-step troubleshooting, multimeter specs, and OEM part numbers.

8 error codes

CodeMeaning
E-PREHEAT-FAILThe control board is sending the signal to heat, but something in the actual heating circuit is broken. Either the element snapped, the gas igniter can't pull enough current to open the safety valve, or a thermal fuse cut the whole circuit. The board thinks it's working. It's not.
highintermediate
E15The E15 error code indicates a communication failure between the main power control board and the user interface (UI) display board.
highintermediate
ELECTROLUX-OVEN-DIAGThe Electrolux oven repair manual refers to the technical service procedures used to enter diagnostic mode, retrieve fault codes, and test internal components like heating elements and sensors.
moderateintermediate
ERR-CODEThe Err prefix means the control board detected a fault, usually in the temperature sensor circuit, the communication link between the main board and the user interface board, or a heat condition that's gone outside normal operating limits.
highintermediate
F050F050 means the main power control board and the user interface board have stopped talking to each other over their internal data line. The oven detects that the handshake is gone and throws a lockout code to prevent unsafe operation.
highintermediate
F11The F11 error code on an Electrolux oven signifies a shorted or stuck key on the touch control panel or user interface assembly. The control board triggers this fault when it detects a continuous signal from a specific button for more than 30 to 60 seconds.
moderateintermediate
F14F14 on an Electrolux oven indicates the control board's EEPROM has failed. Electrolux uses the same error code convention as Frigidaire (Electrolux owns Frigidaire).
highadvanced
NO-HEAT-ELECTROLUXThe oven's control board is sending the right signals but the heating circuit isn't responding. Either a physical component like an element or fuse has failed, or the board itself can't close the relay that sends 240 volts to the heating coils.
highintermediate